Hi, how are you? I had a good one that didn't post at all. so let's start
Recently I was able to push through one of my scalar couple's sets. I've been trying since January and I couldn't.
either because they ate the eggs or when they were removed they spent a few days and they all turned white. finally I repeat just a few days ago if I was able to move on and thinking about food for them I decided to make an Artemiero dish and here the images
Tupper or Round container approx cm high (I occupied the container of some candies)
Black spray can (highly recommended)
and a 2 liter pet container
Depending on the height of our container we cut a strip approx 3.5 cm high. and we form a circle in such a way that this circle is inside our container leaving 2 to 3 cm from the wall of our container. What I did first was that I staple it and then paste it with silicon
At the bottom I made some small cuts so that here the artemia that already hatched passes
The tabs that cut occupy them to glue the circle to the container .. also first staple them and then reinforce them with silicon
Remember the tabs that cut the circle occupied to fix this to the bottom of the container
fix them with silicon
Now that it is fixed we continue to cut another circle smaller than the previous one so that it contains it inside and leaves about 2 cm between walls and about 1/2 cm lower in height
This circle does not make the grooves in the bottom but if we paste 3 tabs like the previous one so that they help us to fix it to the bottom
Sorry for the images but since the packaging is transparent, it didn't feel very good
something like that should be
Well now we go with the lid.
make a hole in the center of the lid so that it fits the mouth of the soda container
Eye this is the mouth of the bottle cut as follows
Now place a piece of cloth with it you can capture the artemia and let the water run. I adjusted it with a league
and ready the artemiero is finished you just need to paint it black to prevent light from entering
In this case I tried with black tape but I do not recommend it since it does not completely let the heat pass and then the water temperature would not be enough (I have it on the aquarium in a glass) but as soon as I get the paint I take the paint off tape and I paint it
Here are some photos of the artemia already hatched at 24 hrs. Ha almost can't be seen. but they are those little points that are seen in the collector
and well after a rinse of artemia, straight to the fry and devoured them.
I think I will have to do another to cover the fry's demand
I leave a small video of the fry
Friends I hope I have been explicit and that the contribution is useful
Oops something very important and not mentioned, is how it works.
well remember the first ring must be high since the eggs float and stay in the first section. When the cysts hatch, they are attracted to the light that enters the center of our plate. so that they swim in the bottom where we made the ranuas, and from there they go to the next hoop that they remember is lower than the first, and then we only pick them up with the collector
I leave this image that describes a bit how it works